Changing the Paper Size
Changing the Paper Size in Non-standard Paper
Tray 2e.g. OHP transparencies, transpar-
ent paper, postcards etc.
ACarry out steps A-J described inA Push the switch-over lever to
"Changing the Paper Size in Traythe right.
1 or the Optional Paper Table" Ţ
P.103 ?Changing the Paper Size in
Tray 1 or the Optional Paper Ta-
ble?.
3Note
r If the size of paper you wish to
load is not shown on the scale,
slide the paper size selector to
the ?p? mark then specify the
paper size and type.
BPush the switch-over lever to theNote
left or right depending on ther When you push the switch-
type of paper you have loaded:over lever to the right, you
cannot use the following
Standard Paperfunctions.
? Sort/Stack/Staple
A Push the switch-over lever to
the left.?Duplex
CPush the paper tray in until it
stops.
Setting the non-standard size paper
APress the 1 key to select the sec-
ond paper tray. Then press the {#}
key.
BPress the [Pap.Size] key.
105 |